RM RM Eye Manuel d'instructions télécharger pdf (Page 12)

RM-eye instruction manual Ver.1.0

3.2 Connect with a RCB-1, RCB-3(J) and PWM-board

In order to communicate with RCB-1, RCB-3(J) and PWM-board, you can connect a 3pin parallel

straight cable to a CN3 on RM-eye. Please refer a pin layout for RCB-1, RCB-3(J) and PWM-board

from their documentations.

You can connect with CN3 to their board with straight cable because CN3 is a crossover serial

output.

Figure 6. Connection with RCB-1, RCB-3(J) and PWM-board

4. RM-eye setup

4.1 Setting parameters using a original software

In order to use RM-eye, you can set up some parameters using a original windows software.

Please refer a RM-eye install manual.

And please refer a help menu in RM-eye windows software concerning detail functions.

CN3

3 2 1

RCB-1, RCB-3(J), PWM-board

1 2 ... 7 8 9 10 11 12 13 14 15

Pas de commentaire

RM RM Eye Manuel d'instructions Page 12